Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1432-1106
    Keywords: Ballistic movement ; Three-burst pattern
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Summary In isotonic and isometric goal-directed index finger movements made as fast as possible, the “braking hypothesis” ascribed to the antagonist burst was tested. Under isotonic conditions, the extensor burst often failed to occur in small angle movements with low inertial load. It regularly occurred, however, in small angle movements with high inertial load and in wide angle movements with both low and high inertial loads. Such features suggest, indeed, the antagonist burst as being part of braking strategies. Under isometric conditions, the antagonist burst — if it occurred — exhibited characteristics which suggested a rapidly alternating movement rather than a braking strategy.
    Type of Medium: Electronic Resource
    Signatur Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1572-8943
    Keywords: cold crystallization ; DSC ; heat capacity ; modulated temperature DSC ; poly(ethylene terephtalate)
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract The modulated temperature differential scanning calorimetric method (MT-DSC) yields three temperature dependent signals, an underlying heat capacity curve from the underlying heat flow rate (corresponding to the conventional DSC signal), and a complex heat capacity curve with a real part (storage heat capacity) and an imaginary part (loss heat capacity). These curves have been measured in the cold crystallization region for poly(ethylene terephtalate) with a modified Perkin-Elmer DSC-7. The underlying curve shows the well known large exothermic crystallization peak. The storage heat capacity shows a step change which reproduces the change in heat capacity during crystallization. This curve may be used as baseline, to separate the crystallization heat flow rate from the underlying heat flow rate curve. The loss heat capacity curve exhibits a small exothermic peak at the temperature of the step change of the storage curve. It could be caused by changes of the molecular mobility during crystallization.
    Type of Medium: Electronic Resource
    Signatur Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1572-8943
    Keywords: calibration material ; calibration procedure ; DSC ; heat calibration ; heat flow rate calibration ; standards ; temperature calibration
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract Metrologically based measuring procedures and evaluation methods are recommended as guidance for practical temperature, heat and heat flow rate calibration of DSC instruments which are largely independent of instrumental, test and sample parameters. The relevant terms are defined, the measuring procedures and evaluation methods described, calibration materials and their characteristic data stated and guidance for the sample handling provided. Reference is made to three extended papers on calibration. The recommendations were developed by the working group ‘Calibration of Scanning Calorimeters’ of the German Society of Thermal Analysis (GEFTA).
    Type of Medium: Electronic Resource
    Signatur Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...