Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

  • Pore fluid chemistry
  • intrapatient variations
  • 1
    ISSN: 1432-1041
    Keywords: tobramycin ; newborn infants ; intrapatient variations ; pharmacokinetics
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Medicine
    Notes: Summary Nineteen newborn infants receiving tobramycin, 2.5 mg/kg every 12 h were studied on two occasions at steady-state during the first week of postnatal age. The two studies were separated by two to four days. Total body clearance of tobramycin averaged 1.15 and 1.14 ml/min/kg (p〉0.05), apparent volume of distribution averaged 0.82 and 0.68 l/kg (p〉0.05), and elimination half-life averaged 8.6 and 7.1 h (p〉0.05), during the first and second study, respectively. When the data were further analyzed based on the birth weight, tobramycin kinetics changed during the second study compared to the first study in very low birth weight infants. In eight infants ⩽1.5 kg birth weight, although total clearance of tobramycin was similar, the average apparent volume of distribution decreased from 1.04 l/kg during the first study to 0.73 l/kg during the second study (p〈0.05) and elimination half-life from 11.1 h during the first study to 8.7 h during the second study (p〈0.05). These data indicate that these infants may require a change in dosing interval with continued tobramycin therapy during the first week of postnatal age. Intrapatient variation in tobramycin kinetics should be considered, in addition to the interpatient variation reported previously, when monitoring the serum concentration to individualize tobramycin therapy in newborn infants ⩽1.5 kg birth weight.
    Type of Medium: Electronic Resource
    Signatur Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1420-9136
    Keywords: Pore fluid chemistry ; Stable sliding ; Fault gouge
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences , Physics
    Notes: Abstract Single-cycle and multiple-cycle frictional-sliding experiments were employed to evaluate the effects of pore fluid environments on yield strength, frictional-sliding dynamics, and gouge production and morphology. Circular right cylinders cored from Berea sandstone sawcut at 35° to the axes were saturated in water, an inorganic brine, and various anionic, cationic, and nonionic aqueous surface-active agents. Samples were deformed under an effective confining pressure of 50 MPa and an axial strain rate of 6×10−5 sec−1 until a 2% axial strain beyond yield (defined as the onset of sliding) was achieved. All samples were displaced by stable sliding. In the single-cycle tests the unsaturated and water-saturated samples displayed small stress peaks at yield. During stable sliding samples saturated with DTAB and SDS displayed slight increases in differential stress and statistically significant higher frictional coefficients than other environments (including water) but were very similar in behavior to dry, unsaturated samples. In the multiple-cycle tests, samples were loaded to 2% strain beyond yield and unloaded to a differential stress of approximately 5–10 MPa a total of four times. These results further suggest that DTAB exerts a ‘strengthening’ effect on the sandstone relative to water which, to a limiting value, increased with displacement. The DTAB and SDS environments also produced a coarser grain-size distribution in the gouge relative to gouge produced in the other environments. Investigation of the gouge by scanning electron microscope revealed that these larger ‘grains’ were composed of dense, apparently cemented aggregates of ultrafine, platy quartz particles.
    Type of Medium: Electronic Resource
    Signatur Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...